Refine
Year of publication
Document Type
- Conference Proceeding (46) (remove)
Has Fulltext
- no (46)
Keywords
- BCH codes (1)
- Binary codes (1)
- Block codes (1)
- Channel estimation (1)
- Codes over Gaussian integers (1)
- Computational complexity (1)
- Data compression (2)
- Decoding (1)
- Digital arithmetic (1)
- Elliptic curve cryptography (1)
Institute
The introduction of multi level cell (MLC) and triple level cell (TLC) technologies reduced the reliability of flash memories significantly compared with single level cell (SLC) flash. The reliability of the flash memory suffers from various errors causes. Program/erase cycles, read disturb, and cell to cell interference impact the threshold voltages. With pre-defined fixed read thresholds a voltage shift increases the bit error rate (BER). This work proposes a read threshold calibration method that aims on minimizing the BER by adapting the read voltages. The adaptation of the read thresholds is based on the number of errors observed in the codeword protecting a small amount of meta-data. Simulations based on flash measurements demonstrate that this method can significantly reduce the BER of TLC memories.
The Lempel-Ziv-Welch (LZW) algorithm is an important dictionary-based data compression approach that is used in many communication and storage systems. The parallel dictionary LZW (PDLZW) algorithm speeds up the LZW encoding by using multiple dictionaries. The PDLZW algorithm applies different dictionaries to store strings of different lengths, where each dictionary stores only strings of the same length. This simplifies the parallel search in the dictionaries for hardware implementations. The compression gain of the PDLZW depends on the partitioning of the address space, i.e. on the sizes of the parallel dictionaries. However, there is no universal partitioning that is optimal for all data sources. This work proposes an address space partitioning technique that optimizes the compression rate of the PDLZW using a Markov model for the data. Numerical results for address spaces with 512, 1024, and 2048 entries demonstrate that the proposed partitioning improves the performance of the PDLZW compared with the original proposal.
This work proposes a suboptimal detection algorithm for generalized multistream spatial modulation. Many suboptimal detection algorithms for spatial modulation use two-stage detection schemes where the set of active antennas is detected in the first stage and the transmitted symbols in the second stage. For multistream spatial modulation with large signal constellations the second detection step typically dominates the detection complexity. With the proposed detection scheme, the modified Gaussian approximation method is used for detecting the antenna pattern. In order to reduce the complexity for detecting the signal points, we propose a combined equalization and list decoding approach. Simulation results demonstrate that the new algorithm achieves near-maximum-likelihood performance with small list sizes. It significantly reduces the complexity when compared with conventional two-stage detection schemes.
This work introduces new signal constellations based on Eisenstein integers, i.e., the hexagonal lattice. These sets of Eisenstein integers have a cardinality which is an integer power of three. They are proposed as signal constellations for representation in the equivalent complex baseband model, especially for applications like physical-layer network coding or MIMO transmission where the constellation is required to be a subset of a lattice. It is shown that these constellations form additive groups where the addition over the complex plane corresponds to the addition with carry over ternary Galois fields. A ternary set partitioning is derived that enables multilevel coding based on ternary error-correcting codes. In the subsets, this partitioning achieves a gain of 4.77 dB, which results from an increased minimum squared Euclidean distance of the signal points. Furthermore, the constellation-constrained capacities over the AWGN channel and the related level capacities in case of ternary multilevel coding are investigated. Simulation results for multilevel coding based on ternary LDPC codes are presented which show that a performance close to the constellation-constrained capacities can be achieved.
The computational complexity of the optimal maximum likelihood (ML) detector for spatial modulation increases rapidly as more transmit antennas or larger modulation orders are employed. Hence, ML detection may be infeasible for higher bit rates. This work proposes an improved suboptimal detection algorithm based on the Gaussian approximation method. It is demonstrated that the new method is closely related to the previously published signal vector based detection and the modified maximum ratio combiner, but can improve the detection performance compared to these methods. Furthermore, the performance of different signal constellations with suboptimal detection is investigated. Simulation results indicate that the performance loss compared to ML detection depends heavily on the signal constellation, where the recently proposed Eisenstein integer constellations are beneficial compared to classical QAM or PSK constellations.
Error correction coding (ECC) for optical communication and persistent storage systems require high rate codes that enable high data throughput and low residual errors. Recently, different concatenated coding schemes were proposed that are based on binary Bose-Chaudhuri-Hocquenghem (BCH) codes that have low error correcting capabilities. Commonly, hardware implementations for BCH decoding are based on the Berlekamp-Massey algorithm (BMA). However, for single, double, and triple error correcting BCH codes, Peterson's algorithm can be more efficient than the BMA. The known hardware architectures of Peterson's algorithm require Galois field inversion. This inversion dominates the hardware complexity and limits the decoding speed. This work proposes an inversion-less version of Peterson's algorithm. Moreover, a decoding architecture is presented that is faster than decoders that employ inversion or the fully parallel BMA at a comparable circuit size.
It is well known that signal constellations which are based on a hexagonal grid, so-called Eisenstein constellations, exhibit a performance gain over conventional QAM ones. This benefit is realized by a packing and shaping gain of the Eisenstein (hexagonal) integers in comparison to the Gaussian (complex) integers. Such constellations are especially relevant in transmission schemes that utilize lattice structures, e.g., in MIMO communications. However, for coded modulation, the straightforward approach is to combine Eisenstein constellations with ternary channel codes. In this paper, a multilevel-coding approach is proposed where encoding and multistage decoding can directly be performed with state-of-the-art binary channel codes. An associated mapping and a binary set partitioning are derived. The performance of the proposed approach is contrasted to classical multilevel coding over QAM constellations. To this end, both the single-user AWGN scenario and the (multiuser) MIMO broadcast scenario using lattice-reduction-aided preequalization are considered. Results obtained from numerical simulations with LDPC codes complement the theoretical aspects.
Today, many resource-constrained systems, such as embedded systems, still rely on symmetric cryptography for authentication and digital signatures. Asymmetric cryptography provide a higher security level, but software implementations of public-key algorithms on small embedded systems are extremely slow. Hence, such embedded systems require hardware assistance, i.e. crypto coprocessors optimized for public key operations. Many such coprocessor designs aim on high computational performance. In this work, an area efficient elliptic curve cryptography (ECC) coprocessor is presented for applications in small embedded systems where high performance coprocessors are too costly. We propose a simple control unit with a small instruction set that supports different ECC point multiplication (PM) algorithms. The control unit reduces the logic and number of registers compared with other implementations of ECC point multiplications.
This work proposes a decoder implementation for high-rate generalized concatenated (GC) codes. The proposed codes are well suited for error correction in flash memories for high reliability data storage. The GC codes are constructed from inner extended binary Bose-Chaudhuri-Hocquenghem (BCH) codes and outer Reed-Solomon (RS) codes. The extended BCH codes enable high-rate GC codes. Moreover, the decoder can take advantage of soft information. For the first three levels of inner codes we propose an optional Chase soft decoder. In this work, the code construction is explained and a decoder architecture is presented. Furthermore, area and throughput results are discussed.
In diesem Beitrag wird die Hardware-Implementierung eines Datenkompressionsverfahrens auf einem FPGA vorgestellt. Das Verfahren wurde speziell für Kompression kurzer Datenblöcke in Flash-Speichern entwickelt. Dabei werden Quelldaten mithilfe eines Encoders komprimiert und mit einem Decoder verlustlos dekomprimiert. Durch die Reduktion der Datenrate kann in Flash-Speichern die Übertragungsdauer zum Lesen und Schreiben reduziert werden. Ebenso ist eine Kompression von Nutzdaten sinnvoll, um zusätzliche Redundanzen für einen Fehlerschutz einfügen zu können, ohne den Gesamtspeicherplatzbedarf zu erhöhen.
Error correction coding based on soft-input decoding can significantly improve the reliability of flash memories. Such soft-input decoding algorithms require reliability information about the state of the memory cell. This work proposes a channel model for soft-input decoding that considers the asymmetric error characteristic of multi-level cell (MLC) and triple-level cell (TLC) memories. Based on this model, an estimation method for the channel state information is devised which avoids additional pilot data for channel estimation. Furthermore, the proposed method supports page-wise read operations.
The binary asymmetric channel (BAC) is a model for the error characterization of multi-level cell (MLC) flash memories. This contribution presents a joint channel and source coding approach improving the reliability of MLC flash memories. The objective of the data compression algorithm is to reduce the amount of user data such that the redundancy of the error correction coding can be increased in order to improve the reliability of the data storage system. Moreover, data compression can be utilized to exploit the asymmetry of the channel to reduce the error probability. With MLC flash memories data compression has to be performed on block level considering short data blocks. We present a coding scheme suitable for blocks of 1 kilobyte of data.
This work investigates data compression algorithms for applications in non-volatile flash memories. The main goal of the data compression is to minimize the amount of user data such that the redundancy of the error correction coding can be increased and the reliability of the error correction can be improved. A compression algorithm is proposed that combines a modified move-to-front algorithm with Huffman coding. The proposed data compression algorithm has low complexity, but provides a compression gain comparable to the Lempel-Ziv-Welch algorithm.
This work investigates soft input decoding for generalized concatenated (GC) codes. The GC codes are constructed from inner nested binary Bose-Chaudhuri-Hocquenghem (BCH)codes and outer Reed-Solomon (RS) codes. In order to enable soft input decoding for the inner BCH block codes, a sequential stack decoding algorithm is used. Ordinary stack decoding of binary block codes requires the complete trellis of the code.
In this work a representation of the block codes based on the trellises of supercodes is proposed in order to reduce the memory requirements for the representation of the BCH codes. Results for the decoding performance of the overall GC code are presented.
Furthermore, an efficient hardware implementation of the GC decoder is proposed.
Digitale Signaturen zum Überprüfen der Integrität von Daten, beispielsweise von Software-Updates, gewinnen zunehmend an Bedeutung. Im Bereich der eingebetteten Systeme kommen derzeit wegen der geringen Komplexität noch überwiegend symmetri-sche Verschlüsselungsverfahren zur Berechnung eines Authentifizierungscodes zum Einsatz. Asym-metrische Kryptosysteme sind rechenaufwendiger, bieten aber mehr Sicherheit, weil der Schlüssel zur Authentifizierung nicht geheim gehalten werden muss. Asymmetrische Signaturverfahren werden typischerweise zweistufig berechnet. Der Schlüssel wird nicht direkt auf die Daten angewendet, sondern auf deren Hash-Wert, der mit Hilfe einer Hash-funktion zuvor berechnet wurde. Zum Einsatz dieser Verfahren in eingebetteten Systemen ist es erforder-lich, dass die Hashfunktion einen hinreichend gro-ßen Datendurchsatz ermöglicht. In diesem Beitrag wird eine effiziente Hardware-Implementierung der SHA-256 Hashfunktion vorgestellt.
This work proposes a construction for low-density parity-check (LDPC) codes over finite Gaussian integer fields. Furthermore, a new channel model for codes over Gaussian integers is introduced and its channel capacity is derived. This channel can be considered as a first order approximation of the additive white Gaussian noise channel with hard decision detection where only errors to nearest neighbors in the signal constellation are considered. For this channel, the proposed LDPC codes can be decoded with a simple non-probabilistic iterative decoding algorithm similar to Gallager's decoding algorithm A.
Generalized concatenated (GC) codes with soft-input decoding were recently proposed for error correction in flash memories. This work proposes a soft-input decoder for GC codes that is based on a low-complexity bit-flipping procedure. This bit-flipping decoder uses a fixed number of test patterns and an algebraic decoder for soft-input decoding. An acceptance criterion for the final candidate codeword is proposed. Combined with error and erasure decoding of the outer Reed-Solomon codes, this bit-flipping decoder can improve the decoding performance and reduce the decoding complexity compared to the previously proposed sequential decoding. The bit-flipping decoder achieves a decoding performance similar to a maximum likelihood decoder for the inner codes.